ENGLISH / A-19FORM NO. 56041978 - BR1100S / BR1300S - A-19SQUEEGEE MAINTENANCEIf the squeegee leaves narrow streaks or water, the blades may be dirty or damaged. Remove the squeegee, rinse it under warm water and inspect the blades.Reverse or replace the blades if they are cut, torn, wavy or worn.To Reverse or Replace the Rear Squeegee Wiping Blade...1 See Figure 11. Raise the squeegee tool off the floor, then unsnap the Center Latch (AA) on the squeegee tool.2 Remove the Tension Straps (BB).3 Slip the rear blade off the alignment pins.4 The squeegee blade has 4 working edges as shown below. Turn the blade so a clean, undamaged edge faces toward the front of the machine. Replace theblade if all 4 edges are nicked, torn or worn to a large radius.5 Install the blade, following the steps in reverse order and adjust the squeegee tilt.To Reverse or Replace the Front Squeegee Blade...1 Raise the squeegee tool off the floor, then loosen the (2) Thumb Nuts (CC) on top of the squeegee and remove the squeegee tool from the mount.2 Remove both rear Tension Straps first.3 Remove all the wing nuts that hold the front blade in place, then remove tension strap and blade.4 The squeegee blade has 4 working edges as shown below. Turn the blade so a clean, undamaged edge faces toward the front of the machine. Replace theblade if all 4 edges are nicked, torn or worn to a large radius.5 Install the blade, following the steps in reverse order and adjust the squeegee tilt.SQUEEGEE ADJUSTMENTThere are two squeegee tool adjustments possible, angle and height.Adjusting the Squeegee AngleAdjust the squeegee angle whenever a blade is reversed or replaced, or if the squeegee is not wiping the floor dry.1 Park the machine on a flat, even surface.2 Lower the squeegee, move the machine ahead slightly and adjust the squeegee tilt and height using the Squeegee Tilt Adjust Knob (22) and SqueegeeHeight Adjust Knobs (28) so that the rear squeegee blade touches the floor evenly across its entire width and is bent over slightly as shown in the squeegeecross section.FIGURE 11