C343 4 09/2017S2 / S3GBVacuum cleaner descriptionOptional kitsPlease contact the manufacturer’s sales network forinformation on optionals.Instructions for installing the optionals are included in theconversion kit.WARNING!Use only supplied and authorized genuine spare parts.AccessoriesVarious accessories are available; refer to the manufacturer’saccessory catalogue.WARNING!Use only genuine accessories supplied andauthorized by the manufacturer.Packing and unpackingDispose of the packing materials in compliance with the lawsin force.Figure 3Model S2 L - M - H(40 L)S3 L - M - HBDC1330(50 L)S3 L - M - HE-VAC2000BDC1330(100 L)A (mm) 700 700 700B (mm) 860 860 860C (mm) 1350 1750 1750Weight withpacking (kg) 80 86 89Unpacking, moving, use and storageOperate on flat, horizontal surfaces.The load-bearing capacity of the surface the vacuum cleaneris placed on must be suitable for bearing its weight).Vacuum Cleaner Parts and LabelsFigure 11. Identification plate which includes:Model code, Class (L - M - H), Technical Specifications(see table on page 6), Serial N°., CE Mark, Year ofmanufacture, Nominal network voltage.2. Dust container3. Dust container release lever4. Inlet5. Inlet (only for Class M - H vacuum cleaners).6. Inlet plug7. Accessories compartment8. Warning label for ClassL -M - H vacuum cleaners.9. Outlet10. Attention plateDraws the operator’s attention to the fact that the filtermust only be shaken when the vacuum cleaner is turnedoff (see also par. “Primary filter shaker”).11. Plug for connecting the vacuum cleaner to an electricalsocket.Figure 21. Class L label2. Class M label3. Class H labelThe class L and M labels contain pictograms with thefollowing meanings:WARNING!This vacuum cleaner contains dusthazardous for the health.Only authorised personnel wearing suitablepersonal protective equipment shouldempty and service the vacuum cleaner, includingremoving the means used to vacuum the dust. Do notuse without the complete filter system in place.The class H label contains the above text.This vacuum cleaner creates a strong air flow which is drawnin through the inlet (4 - Fig. 1) and blown out through theoutlet (9 - Fig. 1).Before turning on the vacuum cleaner, fit the vacuum hoseinto the inlet and then fit the required tool on to the end part(refer to the manufacturer’s accessory catalogue or ServiceCentre).The diameters of the authorised hoses are given in thetechnical specifications table.The vacuum cleaner is equipped with a primary filter whichenables it to be used for the majority of applications.Besides the primary filter, which retains the most commontypes of dust, the vacuum cleaner can be fitted with asecondary filter (absolute H class) with a higher filteringcapacity for fine dusts and dusts that are hazardous to health.