INSTRUCTIONS FOR USE ENGLISH9100001614 - SC250, Scrubtec 334 1107/2016BATTERY CHARGE LEVELThe battery charge level can be viewed on the battery iconLEDs (5).The battery charge percentage depends on the number of LEDslit, as shown in the figure 5.When the first left LED flashes (15 %), the machine will only runfor a few more minutes (this will depend on the characteristics ofthe work to perform).STOPPING THE MACHINE1. Turn off the machine by pressing the switch (2).2. Press the park pedal (10) to lift the brush/squeegee unit.NOTEIf the machine is on but not working (without theoperator’s hands on the grip handles), it automaticallyturns off after 2 minutes.TANK EMPTYINGAn automatic float shut-off system turns off the vacuum systemwhen the recovery tank is full.The vacuum system deactivation is signalled by a suddenincrease in the vacuum motor noise, and the floor is not dried.When the recovery tank is full, empty it according to thefollowing procedure.Recovery tank emptying1. Turn the machine off and press the park pedal.2. Drive the machine to the appointed disposal area.3. Turn and use the handle (A, Fig. 6) to lift the tankscontainer (B) from the machine.4. Remove the cover (C) and empty the recovery tank; rinsethe tank with clean water at the end of the work.Solution tank emptying5. Perform steps 1 to 4.6. Remove the plug (14) and empty the solution tank. Then,rinse the tank with clean water.7. Reinstall the tanks container (13) on the machine body(16), rotate the handle (A) to the horizontal position andreposition the tank cover (C).MACHINE TRANSPORT/PARKING1. Stop and turn off the machine, then press the park pedal(10).2. While holding the machine in this position, drive it to theappointed parking area.3. If necessary, in order to manually lift the machine, bend thehandlebar (24) and grip the handle (25), then transport themachine to the area where it is to be parked.15% 30% 45% 60% 80% 100%Figure 5P100936ABCFigure 6P100937