Nilfisk-Advance SC400 Operating Manual

Also see for Advance SC400: Service manual Operating guidelines Instructions for use

Contents

troubleshooting

Nilfisk-Advance SC400 Operating Manual Manual pdf 1 page image

Nilfisk-Advance A/SSognevej 25DK-2605 BrøndbyDenmarkTel.: +45 43 23 40 50Fax: +45 43 43 77 00mail.com@nilfisk-advance.comwww.nilfisk.comATTENTION! Do not use the machine before you have read and understood the User Manual2. Fill the tank with a solution suitablefor the work to be performed.Always follow the dilution instructionson the label of the chemical productused to prepare the solution. Its tem-perature must not exceed 40°C.1 Disconnect the battery charger cablefrom the electrical main.3. Install the squeegee and fasten itwith the handwheels, then connectthe vacuum hose to the squeegee.4. Place the brush or the pad-holderunder the deck. Use the appropriatebrush to clean the floor.17. Charge the batteries: Connect thebattery charger cable to theelectrical main15. Check and clean the squeegeeblades16. Clean the machine using a dampcloth and where needed use aneutral cleaning product18. Park the machine with the recoverytank cover open12. Clean the filter by: Remove thetransparent cover and the gasket10. At the end of the work. Emptythe recovery tank with the hose. Thenempty the solution tank with thetrasparent hose11. Wash with clean water the recoverytank and the vacuum grid13. Remove the brush/pad and cleanthem14. Take the squeegee off and removedebris.7. Press the solution flow controlswitch as necessary, depending on thetype of cleaning to be performed5. Switch on the brush and vac motorsto activate the machine6. Press the handle switch to engagethe brush and run the machine8. Lower the squeegee with the lever. 9. Press the enabling push-button togetherwith the brush levers for starting floorcleaning. If solution applied flows outsidethe brush housing during use, reduce theflow of solution.If the machine has been used until the Red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure tocarry out this this procedure may cause damage to the batteries. Charging the batteries after every use is recommended.PLEASE ENSURE RED SOCKET IS LEFT DISCONNECTED AFTER RECHARGE IF THE MACHINE IS NOT TO BE USED ON A DAILY BASISOPERATING GUIDELINESSC400

/ 2

Related manuals for Nilfisk-Advance Advance SC400