Nilfisk-Advance SR 1100 P/B Service Manual

Also see for SR 1100 P/B: Manual for use and maintenance

Contents

Nilfisk-Advance SR 1100 P/B Service Manual Manual pdf 39 page image

SERVICE MANUALSTEERING AND BRAKING SYSTEMGBS30N1100(1)2002-01 101BRAKE CONTROL CABLE REMOVAL1. Drive the machine on a level ground.2. Turn the ignition key (10) to OFF position.3. By means of a proper lifting system, hook the machine at the front anchorages (33) and lift it 30 cm from theground. Then securely fix it in this position.4. Remove the nut (A) and the front wheel (B).5. Disengage the brake lever (D) lead-in wire (C); if necessary loosen the register (E).6. Remove the screw (F) and the pulley (G).7. Loosen the registers (E and H) and remove them from their fixing supports.8. Remove the screw (E).9. Cut the clamp (L).10. Remove the cable (M) and recover the pulley (G).11. Install in the reverse order of removal, with the following change:– Before the (M) cable installation, screw down the registers (E and H) completely to facilitate the cableassembly; the first to be registered is (H).12. Carry out the Brake adjustment as described on the previous pages.Figure 4S300124