Side Broom System121Service Manual – SW900Side Broom Height Check and AdjustmentNote: Brooms with harder or softerbristles are available Thisprocedure is applicable to alltypes of broomsNote: This procedure refers tothe right side broom heightadjustment; the procedure forthe left side broom is the same1 Drive the machine on a level floor.2 Turn the ignition key to “I”3 Keep the machine stationary and activatethe side broom lowering control lever; in thisposition run the side broom for a few seconds4 Lift and stop the side broom, then move themachine and turn it off5 Check the side broom print The print is correctwhen the bristles touch the floor along a circlearc (A) as shown in the figure.6 If necessary, adjust the height of the side broom,by using the mechanical end-of-stroke (B) afterloosening the locknut (C); when the adjustmentis completed, tighten the locknut (C).7 When the broom is too worn to be adjusted,replace it (see the procedure in the relevantparagraph)8 Turn the ignition key to “0”Warning! If the side broom print isexcessive, the machineregular operation is affectedand the moving parts orelectrical components canoverheat, thus reducingmachine life.Pay careful attention whenperforming the side broomheight check, and always usethe machine according to theindicated conditions.P200346Maintenance and Adjustments
