Nilfisk-Advance Selectspray 2700G Instructions For Use And Parts List

Contents

Nilfisk-Advance Selectspray 2700G Instructions For Use And Parts List Manual pdf 10 page image

10 Nilfisk-Advance Select Spray 2700G Operator’s ManualINSTALLATION & PREPARATIONATTIRE:1. Proper attire is essential to your safety. It is advised to utilize whatevermeans necessary to protect eyes, ears, and skin. Additional safety attire(such as respiratory mask) may be required when using detergent cleaningagents with this washer.ANSIATTI.TIF/D5SETUP:1. This unit should only be placed on a level surface to ensure proper lubricationfor the engine and water pump while operating.2. Do not use unit in an area:-with insufficient ventilation.-where there is evidence of oil or gas leaks.-where flammable gas vapors may be present.3. Be certain to block the wheels to prevent the unit from moving while operating.4. Do not allow the unit to be exposed to rain, snow or freezing temperatures. Ifany part of the unit becomes frozen, excessive pressure may build up in theunit which could cause it to burst resulting in possible serious injury to theoperator or bystanders.5. Once properly installed, check the oil sight glass (12) on the pump crankcase.Make certain the oil level is in the center of the sight glass before each use.If the level appears low, use SAE 30W non-detergent pump oil. DO NOTOVERFILL!DANGERRISK OF EXPLOSION OR FIRE!DO NOT PLACE UNIT IN AN AREAWHERE FLAMMABLE GASVAPORS MAY BE PRESENT. ASPARK COULD CAUSE ANEXPLOSION OR FIRE!RISK OF UNIT BURSTING!DO NOT STORE/OPERATE UNITIN A FREEZING ENVIRONMENT!WARNINGRISK OF ASPHYXIATION!DO NOT OPERATE IN ANENCLOSED AREA. USE THISPRODUCT ONLY IN WELLVENTILATED AREAS!THE EXHAUST FROM THE ENGINECONTAINS CARBON MONOXIDE,A POISONOUS, ODORLESS ANDINVISIBLE GAS. BREATHINGTHIS GAS CAN CAUSE SERIOUSINJURY, ILLNESS & POSSIBLEDEATH.WARNINGRISK OF EXPLOSION OR FIRE!ALWAYS STORE FUEL AWAYFROM THE WASHER WHILE THEUNIT IS RUNNING OR HOT.DANGERRISK OF FIRE!DO NOT SMOKE WHILE FUELING!DO NOT FILL THE FUEL TANKWHILE UNIT IS RUNNING OR HOT.ALLOW UNIT & ENGINE TO COOLFOR TWO MINUTES BEFOREREFUELING.DO NOT FILL FUEL TANK TOPOINT OF OVERFLOWING.ALLOW APPROXIMATELY 1/4"OF TANK SPACE FOR FUELEXPANSION.ENGINE FUEL TANK:1. Review "Fire & Ventilation Precautions" pg. 4, before fueling.2. Locate the Safety Decals on your unit and heed their warnings. (1-3, 16)3. A minimum of 86 octane fuel is recommended for use with this unit. DO NOTMIX OIL WITH GASOLINE.4. Purchase fuel in quantities that may be used within 30 days. Use of clean,fresh lead free gasoline is recommended. Leaded gasoline may be used iflead-free is unavailable. DO NOT use gasoline containing methanol or alcohol.5. Check the engine oil level before starting the engine. (See Engine manual.)6. Fill the fuel tank according to accompanying engine manual instructions.7. Occasional carburetor and choke adjustments will be necessary for the engine.Refer to the engine manual supplied with this unit for proper adjustmentprocedures.8. Review the engine manual accompanying this pressure washer forcorrect engine start-up and maintenance procedures.