Nine Eagles SOLO PRO 319 RTF Operating Instructions Manual

Contents

Nine Eagles SOLO PRO 319 RTF Operating Instructions Manual Manual pdf 13 page image

Flight preparationOpen the battery compartment and insert the dry or rechargeable cells. Closethe battery compartment. Move all the switches to the forward position, thenswitch the transmitter on (Fig. 1). If switch "A" or "B" is at the "ON" position, thescreen will flash and the transmitter will beep; at these switch positions the trans-mitter cannot be switched off.Move the collective pitch / throttle stick and trim to their lowest position. Other-wise the motors will not start.Carefully pull the canopy forward and off, fit the charged LiPo flight battery intothe support frame on the helicopter, and connect the LiPo flight battery (Fig. 2).Do not touch the throttle control. Do not touch the model for at least three se-conds, otherwise the initialisation process cannot take place.Repeat this procedure every time you wish to fly the model.The "3D" aerobatic switch SW(B) should only be operated by experienced pilots.Moving the switch to the "ON" position sets a system rotational speed suitablefor aerobatics.The hover rotor speed can be adjusted using the "Hover throttle setting" rotaryknob.Note: the 2.4 GHz transmitter and receiver are supplied already bound at thefactory. It will only be necessary to bind the system again after a repair, or if youreplace a component.13Fig. 2Fig. 1AWOperating Instructions, SOLO PRO 319 RTF 2.4 GHz No. NE2517