IS-TWL-DEBUGGER Setup 2008-2009 Nintendo 7 TWL-06-0024-001-ECONFIDENTIAL Released: March 17, 20092 Special Notes2.1 NotesNote the following when using IS-TWL-DEBUGGER.• After you have turned off the IS-TWL-DEBUGGER device, be sure to wait at least five secondsbefore turning the power on again. If you turn it on again immediately, the device may not functionproperly.• Do not turn off the IS-TWL-DEBUGGER device during firmware updates. The IS-TWL-DEBUGGERdevice may not function properly afterward.• During use, do not do anything that would prevent heat dissipation, such as blocking theIS-TWL-DEBUGGER airflow vent, placing the IS-TWL-DEBUGGER in a closed container, or placingobjects on top of the IS-TWL-DEBUGGER.• A connector cable connects the IS-TWL-DEBUGGER main unit ("main unit") to theIS-TWL-DEBUGGER controller unit ("Controller"). Connect the plug with the red band to the lowerplug on the Controller, and connect the plug with the black band to the upper plug (see Table 4-1). Besure to tighten the screws. The device can be damaged if the connector is loose.• The stylus on the Controller cannot be removed. Use the included stylus.• The SD Card slot of the Controller cannot be used. Insert SD Cards into the SD Card slot on the mainunit.• The IS-TWL-DEBUGGER device can be used approximately eight seconds after the power switch isturned on.• When the IS-TWL-DEBUGGER device is sent to Nintendo for repairs or to add options, the systemmenu is initialized. Please back up your data and settings before sending in the device. Also,reconfigure the device after it is returned and before using it.• In the liquid crystal display, you might find pixels that are always illuminated or that never illuminate.Also, you might observe irregularity in color or brightness, depending on the angle of view. These areproperties of the liquid crystal display and are not defects.• This product (both the device and the software) contains encryption functions. Please check localexport control laws before exporting this product.