Nintendo Wii Operation Manual

Also see for Wii U: Operation manual Operation manual Important information Supplementary guide Operation manual

Contents

Nintendo Wii Operation Manual Manual pdf 18 page image

Wii Remote stopped working, re-syncing does not fixthe problem, player LEDs flash and then go off.• Try a fresh set of batteries.• Try resetting the Wii Remote – remove the batteries, wait one minute, then replacethe batteries. Wait a few seconds and then try using the remote again.• The Wii Remote sync information may need to be cleared and the remotesre-synchronized:1. Turn off the console, wait a moment, then turn the console on again.2. When you see the Health and Safety screen, press and hold the SYNCHROButton on the console down for 15 seconds.3. Sychronize your Wii remotes using the proceedure on page 20.• Radio frequency interference may cause the Wii Remote to work erratically. Check forand move or turn off wireless devices such as cordless phones, wireless computerkeyboards or mice or other similar devices.System unable to read disc or game disc will notoperate in consoleNOTE: Game Discs will not start automatically. You must start disc games from the DiscChannel on the Channel Menu screen.• Make sure the disc is inserted correctly. The label side of the disc must face to the rightif the Wii console is set up vertically, or must face up if the Wii console is set uphorizontally.• Check to be sure that the Game Disc is clean and in good condition. If dirty, wipe witha soft cloth, from the center to the outside. Do not wipe with a circual motion.• Eject the Game Disc, and turn the power OFF and then ON. Reinsert the disc and tryplaying the game again.• Check that the Game Disc will work on your version of the Wii. This system will onlywork with Game Discs made for use in the USA, Canada, Mexico and Latin America.Wii Remote or controller accessory buttons stickClean sticking buttons using the following procedure:1. For the Wii Remote, remove batteries and disconnect any accessories beforecleaning.2. Use an unused toothbrush and hot tap water. Do not use boiling water, soapor detergent.3. Dip the toothbrush in hot water and shake off excess amount. Lightly scrubsticking buttons, working the bristles around sides of buttons and into cracks.4. Dry controller with soft cloth or towel and let air dry for at least 2 hours.5. Test buttons and repeat procedure if necessary. Do not submerge in, or pourany type of liquid onto a controller or accessory.Game Disc slot does not light blue or lights briefly.This is the normal operation of the Game Disc slot. The slot only lights temporarilywhen the system is turned on by a) inserting a Game Disc, b) using the PowerButton on the Wii Remote or c) using the Power Button on the Wii console.The Game Disc slot will also light temporarily if you receive a message viaWiiConnect24 (this feature must be turned on to receive messages, see page 59 inthe Wii Operations Manual - Channels and Settings for more information).Unable to proceed passed the Language Select screenduring initial setup.• Make sure you have correctly installed the Sensor Bar. Review pages 13-16 forinstallation proceedure.Tr o u b l e s h o o t i n gFCC Information32 33TroubleshootingF C C I n f o r m a t i o nRegulations for Equipment Use in U.S.A. and CanadaFCC and Industry Canada InformationIn order to comply with FCC radio-frequency radiation exposure guidelines for an uncontrolledexposure, this device and its antenna must not be co-located or operating in conjunction with anyother antenna or transmitter. This device complies with Part 15 of the FCC Rules and RSS-210 ofIndustry Canada. Operation is subject to the following two conditions: (1) this device may notcause harmful interference, and (2) this device must accept any interference received, includinginterference that may cause undesired operation. Changes or modifications not expresslyapproved by the manufacturer could void the user's authority to operate this device.NOTE: This equipment has been tested and found to comply with the limits for a Class B digitaldevice, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonableprotection against harmful interference in a residential installation. This equipment generates,uses and can radiate radio frequency energy and, if not installed and used in accordance with theinstructions, may cause harmful interference to radio communications. However, there is noguarantee that interference will not occur in a particular installation. If this equipment does causeharmful interference to radio or television reception, which can be determined by turning theequipment off and on, the user is encouraged to try to correct the interference by one or more ofthe following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which thereceiver is connected.• Consult the dealer or an experienced radio/TV technician or call NintendoConsumer Service at 1-800-255-3700 for assistance.The user may find the following booklet prepared by the Federal Communications Commissionhelpful: How to Identify and Resolve Radio-TV Interference Problems. This booklet is availablefrom the U.S. Government Printing Office, Washington, D.C., 20402, Stock No. 004-000-00345-4.The term IC before the certification/registration number only signifies that the Industry Canadatechnical specifications were met.If your Wii system still does not operate correctly after tryingthe troubleshooting steps, DO NOT return the console to thestore. You will lose saved game data and all Wii ShopChannel downloads and Wii Points.Visit support.nintendo.com for assistance and additionaltroubleshooting and repair options or call 1-800-255-3700.

/ 19

Related manuals for Nintendo Wii U