NiteRider FireStorm User Manual

Contents

NiteRider FireStorm User Manual Manual pdf 9 page image

7To pivot the headlamp, loosen the2.5 x 12 mm screw located under theslider clip and swing arm and rotatethe headlamp to the desired position.Make this adjustment beforetightening the 2.5 x 30 mm screw.Helmet Mount1. Unclamp the straps on each sideof the helmet mount and pull themfree.2. Position the plastic mounting plateas close to the centerline of thehelmet as possible, orienting theparallel grooves on the slider clipto the rear.3. Feed each strap into and out oftwo helmet vents, circling eachstrap back to the upper edge ofthe corresponding clamp.4. Fasten the straps by inserting them into the clamps.Inserting the Headlamp intothe Handlebar or Helmet MountInsert the headlamp mount into thehandlebar or helmet mount sliderclip from the rear of the slider clipforward. Gently rocking the lamp asyou slide it may help. Do not pushthe release lever when inserting theheadlamp into the slider clip; let thelamp snap into place by itself.To remove the headlamp, push the release lever and slide thelamp backward.Note: After mounting the headlamp, adjust the headlamp soit illuminates the road properly without distracting oncomingriders.Headlamp mount withrelease lever