Manuals database logo
manualsdatabase
Your AI-powered manual search engine

NitroAV Vanguard IIIS Series User Manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Page 20 preview
Page 21 preview
Page 22 preview
Page 23 preview
Page 24 preview
Page 25 preview
Contents
  1. Table Of Contents
  2. Chapter 1: Product Introduction
  3. Functions and Features
  4. Product Specifications
  5. Chapter 2: Hardware Installation
  6. System Requirement
  7. RAID Level set up
  8. How to Change and set up RAID mode
  9. How to Schedule Backup
  10. Steps for changing password
  11. Operation guide when using Windows operating system
NitroAV Vanguard IIIS Series User Manual Manual pdf 20 page image
- 20 -11. Press ” ” button once, screen will display “SETUP PASSWORD OK.”3-6 Operation Guide when using Windows operating system.If VANGUARD IIIS hardware installation has been completed, you can turn on thepower again and connect this device to PC.1. Please connect power cord to power jack on the back of VANGUARD IIIS.2. Connect USB 2.0 or SATA cable to the connection port of Windows operatingplatform that supports this device.3. Turn on the power of VANGUARD IIIS and confirm whether the display oncomputer screen is normal.4. In a few seconds, system will automatically detect this device.5. Verify and confirm whether the icon of this device is listed in the task bar ofWindows desktop.When VANGUARD IIIS and USB 2.0 or SATA device is ready and your set up tospecify the RAID operation mode is done, perform partition and formatting procedureson the hard-disk using disk management tool in control panel of operating system before
/ 25
This manual is suitable for:
Vanguard IIIS Series
Manuals database logo
manualsdatabase
Your AI-powered manual search engine