Chapter 6 Storage, delivery and transportChapter 6 Storage, delivery and transport6.1 Inspection of incoming deliveriesPlease check the shipment immediately after receiving for completeness and intactness. Immediately reportany discovered transport damages to the delivering carrier. Also notify the manufacturer in writing about thiswithout delay. Report any incompleteness in the delivery to the responsible representative or directly to thecompany headquarters of the manufacturer within 2 weeks (see "Branch offices " on page 73).Note: Any claims received thereafter will not be acknowledged!6.2 Scope of deliveryNote: The accu or battery pack required for operation, (see "Accu and battery packs" on page 71) isnot part of the standard scope of delivery and must be ordered separately.The standard scope of delivery of the NivuLog Easy (206.210) includes:l NivuLog Easyl Tool Pen (NLM0TOOLPEN)l 10-pole connector plugl Magnet for device activation (NLM5MAGNET)l Quick guideAdditional equipment such as internal extensions, assembly sets, antennas, accu or battery pack, sensors,power supply, charger, etc., depending on the order. Please check this against the delivery slip.6.3 StorageThe following storage conditions must be observed:NivuLog Easy Storage temperature -30...+85°CHumidity 15...90%rHBP434R Operating temperature -20...+50°CStorage temperature 0...+35°CAP413D+ Operating temperature -50...+60°CCharging temperature -20...+60°CStorage temperature 0... +30°CNote: The table above only includes the storage conditions for the two energy sources used most frequently forthe NivuLog Easy . Please consult the appropriate factsheet for information about the storage conditions ofother accu or battery packs.Important note: Remove the accu or battery pack from the NivuLog Easy prior to storage.Store the measurement technology so that it is protected against corrosive or organic solvent vapours, radio-active emissions and strong electromagnetic radiation.NivuLog Easy - Rev. 05 as of 02.07.2012 19 of 73