Nixie Clock IN-14 Quick Setup Manual

Also see for IN-14 All-In-One: Construction manual Instructions Product manual

Contents

Nixie Clock IN-14 Quick Setup Manual Manual pdf 8 page image

6[Time Zone Minute:.3.2.]: Set the time zone minute , selectable 00/30/50 ;7. Misc ModeFor masc. mode, it displays the [.4.] as index.Long click the [SET] button you can enter the miscellanies setting mode.[Set NIXIE Brightness:.4.1.]: 0(Auto-Brightness)/[1~8] for brightness(8 is thebrightest);[Set LED Brightness:.4.2.]: 0(Off)/[1~3] for brightness(3 is the brightest);[Set LED Auto Change Pattern function:.4.3.]: 0(Disable)/[01]per 1Min/[10]per10Min/[30] per 30Min/[60] per 1hour;[Click Beep Enable:.4.4.]: 0(Disable)/1(Enable);[Set Beep Alert Style:.4.5.]: [0~3] for 4 different beep style;[Set Alarm Beep Loop Times:.4.6.]: in [05~99] range;[Set Middle dots display methord:.4.7.]:[..]On 1 sec/[ ..]On half sec/[....]AlwaysOn/[____(Empty)]Always Off;7. Version Display ModeFor this mode it displays the version num on NIXIE tube, like [.5. 1.00.] means currentsoftware version is 1.00;Long click the [SET] button to enter the setting mode:[.5.1.XXXX] IR Test Mode; It will display the decoded value of infrared codes; Canbe used to determine weather the infrared remote control is working properly;[Reset All]: Set this number to [01], then click the [set] button, all the settingswill be reset to the default, and the clock will reboot itself when finished.About the noiseWe use the PWM signal to adjust the NIXIE tubes' brightness; some tubes do sound whenyou set to the lower brightness levels because of the segments inside the NIXIE tubeseems not installed very tightly. We can't change the tubes structure but we willtry our best to reduce this noise by changing the PWM frequency.Tips: When you set the clock to the highest brightness level (level:8),you can stopthe noise immediately, because in this level, it does not use the PWM signal.