● Password — A password may be needed to make a data connection and isusually provided by your service provider.● Authentication — Select Secure to always send your password encrypted orNormal to send your password encrypted when possible.● Homepage — Depending on the access point you are setting up, enter the webaddress or the address of the multimedia message centre.● Use access point — Select After confirmation if you want the device to ask forconfirmation before the connection using this access point is created, orAutomatically if you want the device to connect to the destination using thisaccess point automatically.Select Options > Advanced settings and from the following:● Network type — Select the internet protocol type to transfer data to and fromyour device. The other settings depend on the selected network type.● Phone IP address (for IPv4 only) — Enter the IP address of your device.● DNS addresses — Enter the IP addresses of the primary and secondary DNSservers, if required by your service provider. To obtain these addresses, contactyour internet service provider.● Proxy server address — Enter the address of the proxy server.● Proxy port number — Enter the port number of the proxy server.Active data connectionsSelect Menu > Settings and Connectivity > Connection mgr..In the active data connections view, you can see the open data connections:data callspacket data connectionsNote: The actual invoice for calls and services from your service providermay vary, depending on network features, rounding off for billing, taxes, and soforth.To end a connection, select Options > Disconnect.To end all open connections, select Options > Disconnect all.© 2009 Nokia. All rights reserved. 113
