1. Open the cover of the memory card slot.2. Insert the card into the memory card slot with the contact surface facing up, andpress until it locks into place.3. Close the cover of the memory card slot.Remove the microSD cardImportant: Do not remove the memory card in the middle of an operation whenthe card is being accessed. Removing the card in the middle of an operation may damagethe memory card as well as the device, and data stored on the card may be corrupted.You can remove or replace the memory card during phone operation without switchingthe device off.1. Ensure that no application is currently accessing the memory card.2. Open the cover of the memory card slot.3. Press the memory card slightly in to release the lock, and remove it.4. Close the cover of the memory card slot.Charge the batteryYour battery has been precharged, but the charging levels may vary.1. Connect the charger to a wall outlet.2. Connect the charger to the device. You can use your device while it ischarging.3. When the battery is fully charged, disconnect the charger from thedevice, then from the wall outlet.If the battery is completely discharged, it may take several minutes beforethe charging indicator appears on the display or before any calls can be made.AntennaYour device may have internal and external antennas. As with any radiotransmitting device, avoid touching the antenna area unnecessarily while theantenna is transmitting or receiving. Contact with such an antenna affects thecommunication quality and may cause the device to operate at a higher powerlevel than otherwise needed and may reduce the battery life.The figure shows the antenna area marked in grey.© 2008 Nokia. All rights reserved.10