67Making an emergency call1 If the phone is not on, switch it on.2 Press and hold for several seconds to ready thephone for calls.3 Key in the emergency number for your present location(e.g. 911 or other official emergency number). Emergencynumbers vary by location.4 Press CallIf certain features are in use (Keyguard, call restrictions, etc.), youmay first need to turn those features off before you can make anemergency call. Consult this document and your local cellular serviceprovider.When making an emergency call, remember to give all the necessaryinformation as accurately as possible. Remember that your wirelessphone may be the only means of communication at the scene of anaccident - do not cut off the call until given permission to do so.Radio frequency (RF) signalsYour wireless handheld portable telephone is a low power radiotransmitter and receiver. When it is ON, it receives and also sendsout radio frequency (RF) signals.In August, 1996, the Federal Communications Commission (FCC)adopted RF exposure guidelines with safety levels for handheldwireless phones. Those guidelines are consistent with safetystandards previously set by both U.S. and international standardsbodies:ANSI C95.1 (1992)*, NCRP Report 86 (1986)*, ICNIRP (1996)*.Those standards were based on comprehensive and periodicevaluations of the relevant scientific literature. For example, over120 scientists, engineers, and physicians from universities,government health agencies and industry reviewed the availablebody of research to develop the ANSI Standard (C95.1).The design of your phone complies with the FCC guidelines (andthose standards).*American National Standards Institute, National Council onRadiation Protection and Measurements; International Commissionon Non-Ionizing Radiation Protection.