Check the type of access point you need with your service provider for the service youwant to access. For availability and subscription to packet data connection services,contact your service provider.Network settingsSelect Menu > Settings and Connectivity > Network.Select from the following:Operator selection — Select Automatic to set the device to search for and select oneof the available networks, or Manual to manually select the network from a list. If theconnection to the manually selected network is lost, the device sounds an error toneand asks you to reselect a network. The selected network must have a roamingagreement with your home network.Cell info display — Set the device to indicate when it is used in a cellular networkbased on microcellular network (MCN) technology and to activate cell info reception.Access pointsCreate a new access pointSelect Menu > Settings and Connectivity > Destinations.You may receive access point settings in a message from a service provider. Some or allaccess points may be preset for your device by your service provider, and you may notbe able to change, create, edit, or remove them.When you open one of the access point groups ( , , ), you can see the access pointtypes:indicates a protected access pointindicates a packet data access pointTo create a new access point, select Access point.The device asks to check for available connections. After the search, connections thatare already available are shown and can be shared by a new access point.If you skip this step, you are asked to select a connection method and to define thesettings needed.To edit the settings of an access point, open one of the access point groups, and selectan access point. Follow the instructions from your service provider.Connection name — Enter a name for the connection.Data bearer — Select the data connection type.Connectivity 79