PAGE 3 (24) Apporved 2.0CMO Operations & Logistics MGRWW Competence TransferMultimedia Creation & Support CONFIDENTIAL 27.9.20051. INTRODUCTIONThe purpose of this document is to help NOKIA service levels 1 and 2 workshop technicians to carry out service toNOKIA products. This Service Manual is to be used only by authorized NOKIA service suppliers, and the content of itis confidential. Please note that NOKIA provides also other guidance documents (e.g. Service Bulletins) for servicesuppliers, follow these regularly and comply with the given instructions.While every endeavor has been made to ensure the accuracy of this document, some errors may exist.If you find any errors or if you have further suggestions, please notify NOKIA using the address below:mailto:cc-ts-rc.documentation@nokia.comPlease keep in mind also that this documentation is continuously being updated and modified, so watch alwaysout for the newest version.Warnings and CautionsPlease refer to the phone’s user guide for instructions relating to operation, care and maintenance includingimportant safety information. Note also the following:Warnings:1.2.3.CARE MUST BE TAKEN ON INSTALLATION IN VEHICLES FITTED WITH ELECTRONIC ENGINEMANAGEMENT SYSTEMS AND ANTI–SKID BRAKING SYSTEMS. UNDER CERTAIN FAULT CONDITIONS, EMITTED RFENERGY CAN AFFECT THEIR OPERATION. IF NECESSARY, CONSULT THE VEHICLE DEALER/MANUFACTURER TODETERMINE THE IMMUNITY OF VEHICLE ELECTRONIC SYSTEMS TO RF ENERGY.THE HANDPORTABLE TELEPHONE MUST NOT BE OPERATED IN AREAS LIKELY TO CONTAINPOTENTIALLY EXPLOSIVE ATMOSPHERES EG PETROL STATIONS (SERVICE STATIONS), BLASTING AREAS ETC.OPERATION OF ANY RADIO TRANSMITTING EQUIPMENT, INCLUDING CELLULAR TELEPHONES, MAY INTERFEREWITH THE FUNCTIONALITY OF INADEQUATELY PROTECTED MEDICAL DEVICES. CONSULT A PHYSICIAN OR THEMANUFACTURER OF THE MEDICAL DEVICE IF YOU HAVE ANY QUESTIONS. OTHER ELECTRONIC EQUIPMENT MAYALSO BE SUBJECT TO INTERFERENCE.Cautions:1. Servicing and alignment must be undertaken by qualified personnel only.2. Ensure all work is carried out at an anti–static workstation and that an anti–static wrist strap is worn.3. Use only approved components as specified in the parts list.4. Ensure all components, modules screws and insulators are correctly re–fitted after servicing and alignment.5. Ensure all cables and wires are repositioned correctly.Electrostatic discharge can easily damage the sensitive components of electronic products.Therefore every Service Supplier has to take care of all precautions, which are mentioned inthe service level related “Service Partner Requirements”, available on NOKIA Online. Also seeESD Protection Requirements in this Service Manual.Service Manual 6060 Level 1&2 Copyright © 2005 NOKIA Corporation. All rights reserved.