Nokia 6101 User Manual

Also see for 6101 - Cell Phone 4.4 MB: User guide Quick start guide User guide User guide User guide

Contents

Nokia 6101 User Manual Manual pdf 43 page image

S e t t i n g s42 Copyright © 2005 NokiaWhen sending or receiving data, ensure that the IR ports of the sending andreceiving devices are pointing at each other and that there are no obstructionsbetween the devices.To activate the IR port of your phone to receive data using IR, select Menu >Settings > Connectivity > Infrared.To deactivate the IR connection, select Menu > Settings > Connectivity > Infrared.When the phone displays Deactivate infrared?, select Yes.If data transfer is not started within 2 minutes after the activation of the IR port,the connection is cancelled and must be started again.IR connection indicatorWhen is shown continuously, the IR connection is activated, and yourphone is ready to send or receive data through its IR port.When blinks, your phone is trying to connect to the other device, or aconnection has been lost.Packet data (EGPRS)Enhanced general packet radio service (EGPRS), packet data, is a network servicewhich allows mobile phones to send and receive data over an Internet protocol(IP)-based network. It enables wireless access to data networks such as the Internet.The applications that may use packet data are MMS, browsing sessions, e-mail,remote SyncML, Java application downloading, and the PC dial-up.To define how to use the service, select Menu > Settings > Connectivity >Packet data > Packet data connection.Select When needed to set the packet data connection to be established when anapplication needs it. The connection will be closed when the application is terminated.Select Always online to set the phone to automatically connect to an packet datanetwork when it is switched on.indicates a packet data connection.Modem settingsYou can connect the phone using an IR or a data cable (CA-42) connection to acompatible PC, and use the phone as a modem to enable packet data connectivityfrom the PC.To define the settings for connections from the PC, select Menu > Settings >Connectivity > Packet data > Packet data settings > Active access point, activatethe access point you want to use, and select Edit active access point. Select Aliasfor access point, and enter a nick name for the currently selected access point.Select Packet data access point, and enter the access point name (APN) to establisha connection to an EGPRS network.