183. Call functions■ Make a voice call1. Enter the phone number, including the area code.For international calls, press * twice for the international prefix (the +character replaces the international access code), enter the country code,the area code without the leading 0, if necessary, and the phone number.2. To call the number, press the call key.To increase the volume in a call, press the top half of the volume key and todecrease press the lower half of volume key.3. To end the call or to cancel the call attempt, press the end key.To search for a name or phone number that you have saved in Contacts, see“Find a contact” on page 25. Press the call key to call the number.To access the list of dialed numbers, press the call key once in the standby mode.To call the number, select a number or name, and press the call key.1-touch dialingAssign a phone number to one of the1-touch dialing keys, 2-9. See “1-touchdialing list” on page 27. Call the number in either of the following ways:• Press a 1-touch dialing key, then the call key.• If 1-touch dialing is activated, press and hold a 1-touch dialing key until thecall begins. See 1-touch dialing in “Call settings” on page 32.Enhanced voice dialingYou can say the name saved in the contact list of the phone to make a phone call.Voice commands are not language-dependent. For voice recognition training, see“Phone settings” on page 33.Note: Using voice tags may be difficult in a noisy environment or during anemergency, so you should not rely solely upon voice dialing in all circumstances.1. In the standby mode, press and hold the right selection key or press and holdthe volume down key. A short tone is played, and Speak after the tone isdisplayed.