O r g a n i z e r815. If you do not enter an exchange rate, the device will prompt you todo so. Select OK. You can edit the exchange rate at anytime.■ TimerThe countdown timer in your device enables you to enter a specific time(up to 99 hours, 59 minutes and 59 seconds). When the time runs out,your device sounds an alarm.Note: The countdown timer only works when the device is on.When you turn off your device, the timer is no longer active.Set the timer1. In the standby mode, select Menu > Organiser > Timer > Normaltimer, Interval timer or Settings.Use Normal timer to measure the countdown time for tasks thathave one period (timer name). Select Interval timer to save sets ofcountdown times with more than one period.2. Enter the time (in hh:mm:ss format), and select OK.3. Enter a note for the timer, and select Start.appears in the standby mode with the countdown timer set. Whenthe time runs out, your device sounds an alarm, displays the timer note,vibrates (if set), and flashes its lights.Press any key during the alarm to stop the alarm. If no keypress duringthe alarm, after 60 seconds the timer alert stops automatically.Change the timeAfter you have set the timer, you can change the time.1. In the standby mode, select Menu > Organiser > Timer > Changetime.2. Enter the new time, and select OK.3. Leave the note as it was, or enter a new note, and select Start.N7088_EN_RUIM_for MEA_clean_021207.fm Page 81 Monday, February 12, 2007 11:20 AM