After SalesTechnical DocumentationInstallation InstructionsPage 10Original 18/96Fixed Mobile Charger LCM–1The fixed mobile charger provides a power supply for the external antenna unitand the mobile phone.Output Power Cable PCC–2The output power cable connects the fixed mobile charger to the external an-tenna unit.Power Cable PCM–5The power cable connects the fixed mobile charger, LCM–1, to the vehicle’spower supply. The red wire must be connected to the + voltage supply con-trolled by the vehicle’s ignition key via the supplied fused connector. The blackwire must be attached to a good negative GND connection.Standard Handsfree Unit PHF–3The standard handsfree unit enables the phone to operate in handsfree mode.The unit is attached to the vehicle interior using mounting plate MKE–7, orswivel mounting plate HHS–7. The mounting must be secured with a screw (de-livered with MKE–7/HHS–7). A temporary installation can be achieved usinginstallation belts (not supplied).Power is supplied from the vehicle’s battery via the power cable PCH–4J. Thestandard handsfree unit provides the power supply to the phone via the systemconnector.The HF microphone, HFM–7, connects to the MIC socket. The phone holder canbe attached to the standard handsfree unit as shown.