Nokia DC-50 User Manual

Also see for DC-50: User guide User manual

Contents

Nokia DC-50 User Manual Manual pdf 7 page image

Charge your charging plateThe built-in battery has been partially charged at the factory, but you may need to recharge it beforeyou can use your charging plate. Charge the plate with a wireless charger, a USB charger, or acomputer.1. To charge wirelessly, place the charging plate on a wireless charger. Make sure the charging areason the two devices touch.Alternatively, when using a USB charger or a computer, first put the micro-USB end of the cable inthe charger connector of your charging plate. Then put the USB end of the cable into the charger andplug the charger into a wall outlet, or connect the cable to a computer.The battery level and charging indicators show the charging progress by blinking steadily while thebattery is charging. The charging time may vary depending on the charging method.If the charging plate becomes too warm, it automatically stops charging for a while.2. When the battery is full, take your plate off the wireless charger, or disconnect the USB cable fromyour charging plate and the charger from the wall outlet.Check the battery levelPress the power indicator key. The indicator lights switch on for 10 seconds, showing you theremaining battery level.Each indicator light represents 25% of the battery capacity. If there's only one blinking light, you needto charge your charging plate before you can use it.© 2013 Nokia. All rights reserved. 7