Nokia IP100 Series Installation Manual

Contents

Nokia IP100 Series Installation Manual Manual pdf 47 page image

IP100 Series Installation Guide 33Using VoyagerUsing VoyagerNow complete the configuration using Voyager:1. Open a web browser on the host machine or system you will use tocomplete the configuration or continue using Lynx.2. In the Location field (in Netscape Navigator) or the Address field (inMicrosoft Internet Explorer) or in a comparable field in another webbrowser, enter the IP address of the interface you configured in Step4—Entering Initial Interface Information (192.168.231.111, forexample). Press E NTER or whatever the browser requires you to do toactivate your entry.3. When prompted, enter the admin username and password. Voyagerautomatically starts.Once in Voyager, you can enable Voyager inline help by clicking the H ELPO N button. The Voyager Reference Guide provides information onspecific tasks. Access the guide by clicking the D OC button.NOTE: If the username dialog does not appear, you may not havea network connection between the host and the NAP. Confirm theinformation you entered during this initial configuration and checkthat all cables are firmly connected. See APPENDIXF, Troubleshooting for troubleshooting information.4. Use Voyager to configure the other interfaces you intend to use on theNAP. First click the C ONFIG button. Then click the Interfaces link.Ethernet physical interfaces appear in this form:eth-sxpyThe x (which is highlighted above) is the slot number and the y (alsohighlighted) is the port number, as in s1p1, or slot 1 port 1.Click the interface you want to configure. Set the link speed (10 Mbits/secor 100 Mbits/sec) and duplex mode (full or half) of the interface. Thedefault ethernet logical IDs include the channel number of the interface