Nokia MEDIAMASTER 9460 S Owner's Manual

Nokia MEDIAMASTER 9460 S Owner's Manual Manual pdf 14 page image

GB 14FIRST TIME INSTALLATIONLNB type• Select the correct LNB type for your configuration, e.g. “Universal”.Type of motor• Select SATSCAN (Astra) if it is a Nokia SatScan motor.• Select DiSEqC (Hotbird) in case the motor you use is controlled by DiSEqC com-mands.Motor antenna configurationIn case you have an antenna motor to control your satellite antenna you have tomake the following settings.• From the “Antenna/Satellite selection” menu select alternative 3 “Motor An-tenna Configuration” and press select.SatelliteIn this example, select Astra because its LNB is connected to the DiSEqC 1 inputon the switch.Predefined channelSelect one of the predefined channels and adjust the antenna until you have a TVpicture from the predefined channel visible in the background.• Press opt to view the predefined channel.Go through the same procedure for the second DiSEqC switch.But this time select 2 from “Switch port” and Hotbird as the satellite.When the configuration of both DiSEqC ports are ready, press select. A confirma-tion that the DiSEqC-switches has been configured will show up. Now it´s timeto start searching for channels.• Press select to continue to the channel search procedure.Please refer to the “Channel search” part on page 15.Switch portHere you select the input for each LNB that will be connected. In this specific ex-ample, the DiSEqC 1 input will be selected first.LNB typeSelect the correct LNB type for your configuration, e.g. “Universal”.LNB Offset voltageIf the cable from any of the LNB’s is very long, it might be necessary to increasethe voltage to these LNB’s by 0.5 V.In most cases nothing has to be altered here. Leave the default value “0 V” as itis. If the switch does not change between horizontal and vertical polarisation, thevoltage to a LNB can be increased later.Increase the voltage only if an LNB does not change polarisation.For each LNB you connect to the DiSEqC switch, the following configu-ration has to be performed.As an example the following part will describe how the LNB intended for Astrawill be configured to the DiSEqC input 1 (A) on the switch and the LNB intendedfor Hotbird to DiSEqC input 2 (B).LNB offset voltageIf the cable from the antenna is very long, the voltage at the LNB could be too lowto change the polarisation. You can increase the voltage to the LNB by 0.5 V.Predefined ASTRA-/HOTBIRD-channel• Select one of the predefined channels and adjust the antenna until you have aTV picture from the predefined channel visible in the background.