Nokia MEDIAMASTER 9800 S Owner's Manual

Also see for MEDIAMASTER 9800 S: Owner's manual

Nokia MEDIAMASTER 9800 S Owner's Manual Manual pdf 11 page image

GB 11This procedure is necessary only if your Mediamaster is con-nected to the TV with an RF lead.To tune your TV to the RF signal you might also need your TVmanual in addition to this manual. The steps below explain whatto do if you have been unable to use SCART leads in your con-nection.• Plug in your Mediamaster.Tuning your TV to the Mediamaster• Select a channel number on the TV that is not currently usedfor other TV channels.• Follow the instructions in your TV manual to tune the TV chan-nel selector to UHF channel 43 (this is the Mediamaster’s fac-tory preset UHF channel). If you are already using this chan-nel, select another non occupied UHF channel between 21to69 on the TV.• For example, if you select UHF channel 45 on your TV, youmust change your Mediamaster to the same channel.Use the or buttons on the front panel of the Mediamaster,or on the remote, to change to the corresponding channel. Youwill see the UHF channel number displayed on the front panelof the Mediamaster.• When you have correctly changed the UHF channel numberyou will see the ”Welcome” menu on the TV screen.If there is interference from other channels you will have tochange the chosen UHF channel.• Follow the instructions in your TV manual to store this UHF chan-nel as the channel used by your Mediamaster. You will have toselect it when you want to watch digital TV/Radio channels.• Once the welcome message is visible, press the OK buttonon the Mediamasters remote control to start the installationprocedure.If for some reason you have to change the RF channel later,you can do this by using TV settings menu further on in thismanual.If you have a VCR connected it must be tuned to a differentUHF channel (between 21 to 69) than the Mediamaster.You may now proceed to “First Time Installation.”Tuning Procedure when RF Connections are Used• Plug in your Mediamaster• Now you will see the ”Welcome” menu on the screen.• Press OK on the Mediamaster remote control to start the In-stallation procedure.You may now proceed to “First Time Installation.”Switching on for the First Time withSCART ConnectionsINSTALLATION OF THE MEDIAMASTER