Nokia Mediamaster 230 T User Manual

Also see for 230 T: User guide

Nokia Mediamaster 230 T User Manual Manual pdf 15 page image

GB 15Connecting the MediamasterProcedure when RF connections are usedThis procedure is necessary only when your Mediamaster isconnected to the TV with an RF lead and no SCART leads areused.To tune your TV to the RF signal you might also need your TVmanual in addition to this manual. The steps below explain whatto do if you have been unable to use SCART leads in your con-nection.• Plug in your Mediamaster to the mains.Tuning your TV to the Mediamaster• Select a programme number on the TV that is not currentlyused for other TV channels.• Follow the instructions in your TV manual to tune the TV chan-nel selector to UHF channel 43 (this is the Mediamaster’s fac-tory preset UHF channel).• Follow the instructions in your TV manual to store this UHF chan-nel as the channel used by your Mediamaster. You will have toselect it when you want to watch terrestrial digital TV channels.• When the First time installation menu is visible, press theSelect button on the Mediamasters remote control to start theinstallation procedure.If the picture quality is bad you can later change the predefinedUHF channel 43 to any other figure between 21 and 69. You willalso have to tune your TV to the same (= the new) channelnumber. Please see RF modulator output channel setting onpage 30.When you have a VCR connected it must be tuned to a differentUHF channel (between 21 to 69) than the Mediamaster.Connecting a HiFi system• Connect an RCA/Cinch stereo cable from the AUDIO L R sock-ets on the Mediamaster to the LINE, AUX, SPARE or EXTRAinput sockets on your HiFi system.• If available you can connect an RCA/Cinch single cable fromthe DIGITAL AUDIO socket on the Mediamaster to a HiFi sys-tem equipped with digital audio input. This output is also usedfor connection to an external Dolby™ digital decoder.Note: To avoid interference you must use screened audio ca-bles. Never connect digital output to any analog input.RF