Nokia N76-1 User Manual

Also see for N76: Specification sheet User guide User guide Brochure User guide

Contents

Nokia N76-1 User Manual Manual pdf 107 page image

Settings107Prompt password—If you must enter the password everytime you log in to a server, or if you do not want to saveyour password in the device, select Yes.Password—A password may be needed to make a dataconnection, and is usually provided by the service provider.Authentication—Select Normal or Secure.Homepage—Depending on the access point you are settingup, enter the web address or the address of the multimediamessaging center.Select Options > Advanced settings to change thefollowing settings:Network type—Select the internet protocol type to use:IPv4 or IPv6. The other settings depend on the selectednetwork type.Phone IP address (for IPv4 only)—Enter the IP address ofyour device.DNS address—In Primary DNS address, enter the IPaddress of the primary DNS server. In Secondary DNSaddress, enter the IP address of the secondary DNS server.Contact your internet service provider to obtain theseaddresses.Proxy server address—Define the address for the proxyserver.Proxy port number—Enter the proxy port number.Packet dataThe packet data settings affect all access points using apacket data connection.Packet data connection—If you select When availableand you are in a network that supports packet data, thedevice registers to the packet data network. Starting anactive packet data connection (for example, to send andreceive e-mail) is quicker. If there is no packet datacoverage, the device periodically tries to establish a packetdata connection. If you select When needed, the deviceuses a packet data connection only if you start anapplication or action that needs it.Access point—The access point name is needed to useyour device as a packet data modem to your computer.Data callThe data call settings affect all access points using a GSMdata call connection.Online time—Set the data calls to automaticallydisconnect after a time-out if there is no activity. To entera time-out, select User defined, and enter the time inminutes. if you select Unlimited, data calls are notautomatically disconnected.