4 — Active toolbar (not displayed during recording)5 — Battery charge level indicator6 — Video quality indicator. To change this setting,select Options > Settings > Video quality.7 — Video clip file type8 — Available recording time. When you arerecording, the current video length indicator alsoshows the elapsed and remaining time.9 — The location to which the video clip is saved.10 — GPS signal indicatorRecord videos1. If the camera is in the image mode, select thevideo mode from the active toolbar.2. To start recording, press the capture key. The redrecord icon ( ) is displayed and a tone sounds.3. To pause recording at any time, press Pause.Select Continue to resume. If you pauserecording and do not press any key within oneminute, the recording stops.To zoom in or out of the subject, use the zoomkey in your device.4. To stop recording, press the capture key. Thevideo clip is automatically saved in Photos. Themaximum length of a video clip is approximately30 seconds with sharing quality and 90 minuteswith other quality settings.To activate the front camera, select Options > Usesecondary camera. To start recording a video,press the scroll key. To zoom in or out, scroll up ordown.Camera settingsThere are two kinds of settings for the camera:setup settings and main settings. The setup settingsreturn to the default settings after you close thecamera, but the main settings remain the sameuntil you change them again. To adjust the setupsettings, use the options in the active toolbar. See"Colour and lighting settings", p. 45. To changethe main settings, in the image or video mode,select Options > Settings.Still image camera settingsTo change the main settings, in the image mode,select Options > Settings and from the following:● Image quality — Set the resolution (maincamera only). The better the image quality, themore memory the image consumes.● Add to album — Save the image to an album inPhotos.44 English