Camera25Activate. The device beeps when the timer is running. Thecamera takes the picture after the selected delay elapses.To switch off Self timer, in the active toolbar, select Selftimer > Off.You can also use the self-timer in the sequence mode.Tip! In the active toolbar, select Self timer > 2seconds to keep your hand steady when taking apicture.Record videos1 To activate the main camera, open the slide. If thecamera is in the Image mode, select Switch to videomode from the active toolbar.2 Press the capture key to start recording. In the portraitmode, use the scroll key for recording. The red recordicon is shown and a tone sounds, indicating thatrecording has started.3 Select Stop to stop recording. The video clip isautomatically saved to the Images & video folder ofGallery. See ‘Gallery’, p. 28. The maximum length of thevideo is 60 minutes (if enough memory is available).To pause recording at any time, press Pause. The pauseicon ( ) blinks on the display. Video recordingautomatically stops if recording is set to pause and thereare no keypresses within a minute. Press the capture keyagain to resume recording.To zoom in or out of the subject, press the zoom key on theside of the device.To make lighting and color adjustments before recordinga video, use the scroll key to scroll through the activetoolbar. See ‘Setup settings—Adjust color and lighting’,p. 23 and ‘Scenes’, p. 24.To free memory before recording a video, select Options >Go to free memory (only available if you have backed upimages or video clips). See ‘Free memory’, p. 30.To activate the front camera, select Options > Usesecondary camera.Video capture indicatorsThe video viewfinder displays the following:• The current capture mode indicator (1).• The video stabilization indicator (2)• The audio mute on indicator (3).• The active toolbar (4), which you can scroll throughbefore recording to select the scene, white balance,and color tone (the toolbar is not displayed duringrecording).