Nokia RM-42 Service Manual
Also see for RM-42: Service manual
                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                          | |
8. If the values are OK, click Yes to save the values.9. Close the tuning window.Alternative steps• From the "Operating mode" dropdown menu, set mode to "Local".• From the Tuning menu, choose WCDMA -> Rx AGC Alignment.• Click Start.• Check the “Tune Rx Band Response” checkbox and click Tune.• Setup the signal generator according to the values in the pop-up window:Frequency list: 2113.4 MHz, 2141 MHz and 2166.6 MHzDwell time: 2 msSweep control: Automatic continuous sweepLevel: –48 dBm + cable and adapter attenuationsModulation: FMDeviation: 500 kHzModulation frequency: 50 kHz• Click OK.• Check that the “Rx chain” , “Low freq.” and “High freq.” values in the Tuning Results window are within thelimits presented in the following table.RM-42RF Troubleshooting and Manual Tuning Guide Nokia Customer Care9241872 (Issue 1) Company Confidential Page 7–47Copyright ©2005 Nokia. All Rights Reserved. |
Related manuals for Nokia RM-42
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine