3 |Before you startMake sure your phone is able to connect to the Internet and allows software to beinstalled. If you are unsure how to do this, please read the manual that came with yourphone or contact the supplier of your mobile phone service.Download and InstallationPlease follow the steps below to download and install the MobileTalk software to yourphone. If you have any questions about the installation process, please contact yoursupplier.Open text message:1.Open the link in the “Welcome to MobileTalk” message to take you to thedownload page for the MobileTalk software. If you cannot open the link, clickthe options button and select “Automatic find on” from the menu.Follow links:2.Select and open the link to “Download Now!” to begin downloading theMobileTalk software.Download:3.Open the link to download. Once the download is complete, you will beprompted to install the downloaded file. Click “Open” and follow the on-screeninstructions and press “Yes” to go past the security warning.Install:4.Once the download is complete, you will be prompted to install the down-loaded file. Click “Yes” and follow the on-screen instructions. An “installationcomplete’ prompt confirms when this is successful.Software Menu:5.MobileTalk will continue to work if you switch your phone off and on again. Ifyou need to turn off this service then you can do it from the MobileTalk set-tings menu, as shown. If you have any questions about this service please con-tact support.Software Menu:6.In the Software menu you will find three folders. “Settings”, “Account” and “CallSupport”. Pressing the “Call Support” folder will connect you directly to cus-tomer support.Settings Menu:7.In this menu you will be able to switch the application on and off by changingthe mode. You will also be able to change your access number and dial flow, ifapplicable.Account Menu:8.In this menu you will find your registered number. This field cannot be edited.You will also find the PIN field, which, depending on your account withMobileTalk, can be edited. Make sure you click on “save” for any changes made.