85 Ultrasonic Sensor Installation5.1 Bracket AssemblyAssemble the breakaway sensor bracket as illustrated in Figure 5, following the instructionsbelow.Figure 5: Breakaway Bracket Assembly1. Compress the spring and insert it together with the collar into the base.2. Slide the tube through the assembled part.3. Using the bolt and nut, tighten the collar to the tube with the sensor tube centered.4. Apply a small amount of grease to the rotating surfaces of the bracket.

Introduction

General UC4.5 System Layout

Kit Part

Ultrasonic Sensor Installation

CABLE VALVE VARIABLE RATE DT

CABLE UC4.5 EXTENSION VALVE GENERIC

CABLE UC4 INTERFACE GP ALL

CABLE UC5 BATTERY PIGTAIL FUSED - 5A

Norac UC 4.5 Installation Manual

Hydraulic Installation

Software Setup

Cable Drawings

UC4.5

Electrical Installation

CABLE UC4 INTERFACE ROLL SENSE DT

CABLE UC4 INTERFACE DT2 MAIN EXTENSION

CABLE UC5 BATTERY AMP FUSED - 5A

Roll Sensor Installation

Completing the Factory Installation

End User Installation

list of parts