Norac UC4+ Installation Manual

Also see for UC4+: Installation manual Installation manual Manual Installation manual Operator's manual

Contents

Norac UC4+ Installation Manual Manual pdf 16 page image

134.3 H YDRAULIC I NSTALLATION4.3.1 Valve Mounting1. On a clean surface remove all plasticplugs from the NORAC hydraulic Valve(V01) (Figure 14).2. Install the orifices (F06) into the “B”ports with the notch facing outwardas shown in Figure 15.Figure 14 – NORAC Valve Block3. Install the 6MB-6MJ fittings (F04) intothe “B” ports and tighten to 18 ft-lbs.4. Install the 6MB-plugs (F05) into the “A”ports and tighten to 18 ft-lbs.Figure 15 – Valve Block Assembly5. Mount the NORAC valve (V01) on thesprayer. The bolts should thread intothe valve block at least 3/8”. The valvemounting holes are drilled and tapped3/8 NC-1" deep. The rule of thumb forbolt length is 1-1/2" longer than thetube size.

/ 29

Related manuals for Norac UC4+

Norac UC4+ Installation Manual

This manual is suitable for:

UC4+

manualsdatabase

Your AI-powered manual search engine