Ninox Camera Quick Start Guide3(Rev A)2 Hardware Installation2.1 Hardware Setup InstructionsStep 1Insert CBL31 USB connector (USB3.0 micro b)into the USB3.0 receptacle on the camera.Tighten BOTH thumb screws to the secureCBL31 to the camera.Note: Failure to connect CBL31 to the camerawith BOTH thumb screws can result indamage to the USB3.0 receptacle on thecamera.Step 2Insert the stereo jack portion of CLB31 intothe receptacle on the camera.Step 3Insert the USB Type A end of CBL31 into aUSB3.0 port on the host computer.Note: ONLY two cameras per USB controlleror USB hub are supported.Step 4Insert the stereo jack portion of CBL31 intoany of the “Sync Out” ports of the MyoSyncstation.

Noraxon Ninox 125 Quick Start Manual