Ultium EMG Hardware User Manual25(Rev J)7 Additional Ultium EMG Settings and Features7.1 Ultium Receiver SynchronizationThe Ultium System may be used with other devices. In order to synchronize the signal of the UltiumSystem with these other devices, it is necessary to set up both the software and hardware correctly.The Receiver can accept a sync pulse via the Sync In port located on the back of the Receiver unit.7.1.1 Sync InThe Sync In port allows a capture of a TTL (0-5V) sync signal. The key purpose is to allow Ultium datato be synchronized with data from other devices.7.1.2 MR3 Sync SetupUltium Receiver Sync is set up in the MR3 software, in Hardware Setup, which is found under theGeneral tab. To enable Sync, simply check the Use Noraxon MyoSync checkbox.
