Norcold 1200 Installation Manual

Also see for 1200: Service manual Service manual Owner's manual Owner's instructions Parts list

Contents

Norcold 1200 Installation Manual Manual pdf 6 page image

Installation Manual 6NOTE: The doors are made to accept decorative panels. Thedecorative panels must be 3/16 inch or less inthickness. Install the decorative door panels in therefrigerator doors before installing the refrigerator inthe vehicle.1. Make two upper door panels that are 16 13/64 inches wide x18 3/8 inches high:- Raised panels must be centered on each door and nolarger than 15 11/32 inchs wide x 17 17/32 inches high.2. Make two lower door panels that are 16 13/64 inches wide x41 13/64 inches high:- Raised panels must be centered on each door and nolarger than 15 11/32 inchs wide x 40 11/32 inches high.3. Install the decorative door panels:- Pull the panel retainer [37] off of each door [39] (SeeArt00965).- Push a decorative door panel [38] into the slots of eachdoor.- Make sure that each panel retainer is correctly positionedand push the curved snap [125] of the panel retainer [37]inside of the curved snap [126] of the door (See Art01648).Install Decorative Door Panels (non-metaldoor models)- Make sure that the back of the solid box baffle isperpendicular to the bottom of the enclosure.- Make sure that the horizontal top of the solid boxbaffle is even with the bottom edge of the upperexhaust vent [24].- Make sure that the vertical top edge of the baffle is1/4 inch or less [124] below the lower rear cornerof the condenser [11].- Make sure that there is 1/4 inch or less clearance[124] between the rear of the condenser and thebaffle.1. Put the refrigerator in position:WARNING: Make sure the combustion seal is notbroken, is completely around the refrigerator mountingflanges, and is between the mounting flanges and thewall of the enclosure If the seal is not complete, exhaustfumes can be present in the living area of the vehicle.The breathing of exhaust fumes can cause dizziness,nausea, or in extreme cases, death.NOTE: Be careful when you put the refrigerator into position.The refrigerator has vacuum insulating panels on thetop and sides. If punctured, these panels loseinsulation value which decreases the cooling perfor-mance of the refrigerator. It is not necessary to removethe protective packaging from the doors of metal doormodels to install or operate the refrigerator.- Make sure that the flue cap is not pushed down against thetop of the flue tube.- Push the refrigerator into the enclosure so the side trim isapproximately one inch from the wall.2. Make sure that the side trim pieces [127] are in the correctposition (See Art01649 and Art01650):- Slide both side trim pieces up or down as necessary sothat the ends of the side trim pieces are fully covered by theupper and lower trim pieces [40 and 128].- Pull the left hand side trim piece toward the left as far as itwill go so that there is no gap between the edge of the sidetrim piece and the upper and lower trim pieces.- Pull the right hand side trim piece toward the right as far asit will go so that there is no gap between the edge of theside trim piece and the upper and lower trim pieces.- Push the refrigerator completely into the enclosure.3. Install the mounting screws and trim:- Put the upper trim piece [40] onto the front of the refrigerator(See Art01649).- Put the four screws [41] through the mounting flange on thefront of the refrigerator and into the enclosure wall.- Put a cap plug [129] on each of the screw holes in the uppertrim piece on the front of the refrigerator.WARNING: Do not omit the lower trim piece. Thispiece is part of the combustion seal.Install the Refrigerator