Norcold 1200XX Owner's Manual

Also see for 1200: Service manual Service manual Installation manual Owner's instructions Parts list

Contents

Norcold 1200XX Owner's Manual Manual pdf 13 page image

Owner’s Manual 13Reinstall the RefrigeratorYour dealer or Norcold authorized service center must do thisprocedure.WARNING: Make sure the combustion seal is notbroken, is completely around the refrigerator mountingflanges, and is between the mounting flanges and thewall of the enclosure. If the combustion seal is notcomplete, exhaust fumes can be present in the livingarea of the vehicle. The breathing of exhaust fumes cancause dizziness, nausea, and in extreme cases, death.1. Push the refrigerator completely into the enclosure.2. Install the screws in the mounting flange at the rear of therefrigerator.3. Install the screws from the upper and then the lower mount-ing flanges on the front of the refrigerator.4. Put the plastic plugs into the mounting flanges of therefrigerator.WARNING: To avoid possible propane gas leaks,always use two wrenches to loosen and tighten the LPgas supply line connections.5. Attach the gas supply line to the bulkhead fitting of therefrigerator.6. Open the valve at the propane gas tank(s).WARNING: Do not allow the leak checking solution totouch the electrical components. Many liquids areelectrically conductive and can cause electrical shortsand in some cases, fire.7. Using a leak detecting solution, examine the gas supply linefor leaks.8. Connect the DC wiring to the refrigerator:- Connect the DC wires to the refrigerator.- Install the DC fuse or connect the DC wiring to the battery orthe converter.9. Connect the black AC power cord and the white ice maker ACpower cord (optional) to the receptacle.Remove the RefrigeratorYour dealer or Norcold authorized service center must do thisprocedure.CAUTION: The rear of the refrigerator has sharp edgesand corners. To prevent cuts or abrasions when workingon the refrigerator, be careful and wear cut resistantgloves.WARNING: To avoid possible propane gas leaks,always use two wrenches to loosen and tighten the gassupply line connections.1. Close the valve at the propane gas tank(s).2. Remove the black AC power cord and the white ice maker ACpower cord (optional) from the receptacle.3. Remove the DC wiring from the refrigerator:- Put a mark on the DC wires so you can put them back in thecorrect location.- Remove the DC fuse or remove the DC wiring from thebattery or the converter.- Remove the DC wires from the refrigerator.4. Open the lower intake vent and remove the gas supply linefrom the bulkhead fitting of the refrigerator.5. Remove the plastic plugs from the mounting flanges of therefrigerator.6. Remove the screws from the upper and lower mountingflanges on the front of the refrigerator.7. Remove the screws from the mounting flange at the rear ofthe refrigerator.8. Remove the refrigerator from the opening.!!!!!