Owner’s Manual 18Replacement PartsYou may purchase replacement parts through your local RV dealer or authorized Norcold Service Center.Reinstall the RefrigeratorYour dealer or Norcold authorized service center must do this procedure.WARNING: Make sure the combustion seal is not broken, is completely around the refrigerator mounting flanges, and isbetween the mounting flanges and the wall of the enclosure. If the combustion seal is not complete, exhaust fumes can bepresent in the living area of the vehicle. The breathing of exhaust fumes can cause dizziness, nausea, and in extreme cases,death.1. Push the refrigerator completely into the enclosure.2. Install the screws in the upper and then the lower mounting flanges on the front of the refrigerator.3. Install the screws in the mounting flange at the rear of the refrigerator.4. Push the top and bottom trim pieces onto the to front of the refrigerator until they “snap” into position.WARNING: To avoid possible propane gas leaks, always use two wrenches to loosen and tighten the LP gas supply lineconnections.5. Attach the gas supply line to the bulkhead fitting of the refrigerator.6. Open the valve at the propane gas tank(s).WARNING: Do not allow the leak checking solution to touch the electrical components. Many liquids are electrically conductiveand can cause electrical shorts and in some cases, fire.7. Using a leak detecting solution, examine the gas supply line for leaks.8. Connect the DC wiring to the refrigerator:- Connect the DC wires to the refrigerator.- Install the DC fuse or connect the DC wiring to the battery or the converter.9. Connect the black AC power cord and the white ice maker AC power cord (optional) to the receptacle.!!!