Installation Manual 3The completed installation must:- Make sure there is sufficient intake of fresh air for combustion.- Make sure the living space is completely isolated from the combustion system of the refrigerator.- Make sure there is complete and unrestricted ventilation of the flue exhaust which, in gas mode, can produce carbonmonoxide. The breathing of carbon monoxide fumes can cause dizziness, nausea, or in extreme cases, death.- Make sure the refrigerator is completely isolated from its heat generating components through the correct use ofbaffles and panel construction.WARNING!CAUTION!Art01290Certification and Code Requirements- Do not bypass or change the refrigerator’s electrical components or features.- Do not spray liquids near electrical outlets, connections, or the refrigerator components. Many liquids are electricallyconductive and can cause a shock hazard, electrical shorts, and in some cases fire.- The refrigerator cooling system is under pressure. Do not try to repair or to recharge a defective cooling system.- The cooling system contains sodium chromate. The breathing of certain chromium compounds can cause cancer. Thecooling system contents can cause severe skin and eye burns, and can ignite and burn with an intense flame. Do notbend, drop, weld, move, drill, puncture, or hit the cooling system.- The rear of the refrigerator has sharp edges and corners. To prevent cuts or abrasions when working on therefrigerator, be careful and wear cut resistant gloves.This refrigerator is certified by CSA International as meeting thelatest edition of ANSI Z21.19 / CSA 1.4 standards for installationin mobile homes or recreational vehicles.The installation must obey these standards and this “InstallationManual” for the NORCOLD limited warranty to be in effect.Installation must conform with the following as applicable:In the United States and Canada:- Local codes, or in the absence of local codes, the NationalFuel Gas Code, ANSI Z223.1/NFPA 54, the Natural Gas and Propane installation Code, CSA B149.1, ANSI A119.2 RecreationalVehicles Code, and CSA Z240 RV Series, Recreational Vehicles.- A manufactured home (mobile home) installation must conform with the Manufactured Home Construction and Safety Standard,Title 24 CFR, Part 3280 [formerly the Federal Standard for Mobile Home Construction and Safety, Title 24 (part 280), and thecurrent CSA Z240.4, Gas-equipped Recreational Vehicles and Mobile Housing.- If an external power source is utilized, the appliance, when installed, must be electrically grounded in accordance with local codesor, in the absence of local codes, the National Electrical code, and ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22.2.Parts 1 and 2.All propane gas supply piping and fittings must obey local, state, and national codes about type and size. These components must alsoobey the current NFPA 1192 section 2-4, and in Canada with the current CAN 1-6.10 Standard.Ventilation Requirements