Norcold 962 Operator's Manual

Also see for 962: Installation requirements Service manual & parts list Parts list

Contents

Adjustable ShelvesMultiple shelf grooves in the freezer andfresh food compartments enable you to re-move the shelves for cleaning and to arrangethe shelves to fit your needs. To move the shelfin the freezer, pull the shelf forward, select thenew location, and slide the shelf into place.To move the shelves in the fresh food com-partment; using a Phillips screwdriver, re-move the three screws from each retainer.Lift and pull the retaining strips away fromthe refrigerator. Pull the shelves forward toremove, select the new location, then slidethe shelf into place. Reinstall the retainerstrips by reversing the above procedure.To prevent child entrapment, Insure theshelf retainers are reinstalled and secure.This will also prevent the shelves from shift-ing during transit.Door AlarmIf the lower door remains open and the interior light remains on for more than two minutes, the light turns off, a warningbeeper sounds, a bell flashes, and code A3 appears in the center display panel. Refrigerator operation will not beinterrupted; this alarm is intended to alert you to the fact that the door is ajar. Closing the door will turn off the alarm.Refrigerator Controls and Operating InstructionsWarning: Improper refrigerant flow or cooling system blockage can cause severe personal injury,substantial property damage, or irreparable damage to the cooling system. Do not leave refrigeratorunattended for more than one (1) hour after initial refrigerator start-up. If no cooling is observed inthe freezer compartment within one (1) hour of initial start-p, turn refrigerator OFF and contact yourdealer or an authorized Norcold Service Center for corrective action.A 12 volt DC supply is required to maintain the refrigerator’s operating control functions. The refrigerator receives its DC power fromthe vehicle’s 12 volt system; either an auxiliary battery, a converter or engine battery. The 12 VDC system not only supplies power tothe refrigerator, but to other DC components in the vehicle.The control panel, positioned between the freezer compartment and the fresh food compartment, conveniently locates all ofthe functionality needed by the owner. The window (B) of the control panel is equipped with a light which illuminates theLCD display. This light turns on when any button is pressed, and remains on for 10 seconds after the button is released.The "On/Off" button (E) turns refrigerator "On" or "Off". When refrigerator is "Off", pressing this button will turn refrigerator"On" and set the mode to "AUTO". When refrigerator is "On", pressing this button for 2 seconds will turn refrigerator "Off".Figure 7RetainerStripsMounting ScrewsAbout Your RefrigeratorA B C D EControl Panel - Figure 9Operating Controls8