Norcold DC558 Series Installation Manual

Also see for DC558 Series: Service manual Owner's manual

Contents

Installation Manual 4Assemble the Enclosure1. Make sure the enclosure is:- 42.63 - 42.69 inches high x 23.69 - 23.82 inches wide x 22 inches deep for DC558 models.2. Make sure the floor is solid and level.- The floor must be metal or a wood panel and extend the full width and depth of the enclosure.- The floor must be able to support the weight of the refrigerator and its contents.3. Make sure there are no adjacent heat sources such as a furnace vent, a hot water heater vent, etc.4. If there is more than 1/2 inch between either side of the refrigerator and the inside of the enclosure:- Fill the space with fiberglass (batt-type) insulation or add a baffle to eliminate the clearance.Put the refrigerator in position (see Art02504)- Remove the door from the refrigerator (See “Reverse the door swing” section).- Put screws through the holes of the refrigerator mounting flanges and into the enclosure wall.- Attach the door to the refrigerator.Install the RefrigeratorART 02504121121