Norcold DE-0041 Installation And Owner's Manual

Also see for DE / EV 0041: Owner's manual Installation manual Parts list Service manual Service manual

Contents

Norcold DE-0041 Installation And Owner's Manual Manual pdf 12 page image

Installation and Owner’s Manual 12Install the Refrigerator1. Fasten the refrigerator into the enclosure (See Art01668):- Push the refrigerator fully into the enclosure opening.NOTE: DE/EV0041 models have four mounting screws andDE/EV0061 models have six mounting screws.- Put the mounting screws [4] through the mounting flange [5]on both sides of the refrigerator.- Make sure the mounting screws are through upperhole [6] of each pair of holes in the mounting flanges.CAUTION: If the mounting screws are notthrough the upper hole of each pair of holes in themounting flanges, the side trim pieces will not fitcorrectly.2. Install the side trim pieces (See Art01669 and Art01670):- Open the door(s).- Push the top only of each side trim piece [7] onto the metalframe [8] of the refrigerator.NOTE: You may need to pierce a hole in the door gasketallow the screw to engage to door hinge.- Put the plastic cap in the hole that is opposite the upperhinge of each door.5. Install the lower door:- Make sure a hinge bushing is in the top of the upper doorhinge.- Push the upper door hinge up onto the center hinge pin.- Allow the door to close and put the bottom of the lower doorhinge onto the lower cabinet hinge of the refrigerator.- Make sure a hinge bushing is in the bottom of the lowerdoor hinge.- Align the holes in lower door hinge and the lower cabinethinge.- Turn the lower hinge pin down into the lower cabinet hinge.6. Install the upper door:- Make sure a hinge bushing is in the bottom of the lowerdoor hinge.- Put the lower door hinge down onto the center hinge pin.- Allow the door to close and put the top of the upper doorhinge under the upper cabinet hinge of the refrigerator.- Make sure a hinge bushing is in the top of the upper doorhinge.- Align the holes in upper door hinge and the upper cabinethinge.- Turn the upper hinge pin up into the upper cabinet hinge.- Turn a center hinge pin cap back onto each end of thecenter hinge pin.7. Align the doors and tighten all of the screws.8. Seal all of the screw holes in the door gasket using a 100%silicone multi-purpose sealant that is safe for food contact:NOTE: Read and follow the instructions on the packaging ofthe silicone sealant.- Pull the door gasket away from the door.- Locate the half-moon shaped openings in the door (SeeArt00985).- Apply some of the silicone sealant between the door gasketand the plastic door liner and also fill the screw holeopening.Connect the Drain TubeCAUTION:If you do not remove the orange cable tie from the draintube, the result will be water inside the refrigerator.If you do not connect the drain tube to another tube, theresult will be water at the rear of the refrigerator.1. Remove and discard the orange cable tie that seals thedrain tube at the rear of the refrigerator.2. Attach the drain tube to another tube which allows the defrostwater of the refrigerator to correctly drain to a sump or to anarea outside the vehicle.- Push the door gasket back against the door to allow thegasket to seal against the silicone sealant.- Smooth the silicone sealant in the screw hole opening so itis even with the door cap.- Remove any excess silicone sealant from the door cap witha dry paper towel.- Trim off any excess cured silicone sealant.