Norcold N1095 Installation Manual

Also see for N1095 Series: Parts list Parts list Owner's manual

Contents

Norcold N1095 Installation Manual Manual pdf 12 page image

Installation Manual 122. Push the MODE button [2] until “AU” appears in centerdisplay [4].3. Push the TEMP SET button [3] as needed to set the thermo-stat at “4-6” temperature setting.- If “AU” “AC” appears in the center display, it means that:- 120 volt AC power is available to the refrigerator.- The refrigerator is operating on AC electric power.- After ten seconds, the “AU” “AC” goes off and only agreen dot “.” remains to show that the refrigerator isoperating.- If “AU” “LP” appears in the center display, it means that:- 120 volt AC power is not available to the refrigerator.- The refrigerator is operating on propane gas.- After ten seconds, the “AU” “LP” goes off and only agreen dot “.” remains to show that the refrigerator isoperating.Manual Mode Operation:1. Push the ON/OFF button [1] to start the refrigerator.2. Push the MODE button [2] until “LP” shows in the centerdisplay [4].3. Push the TEMP SET button [3] to set the thermostat at “4-6”temperature setting.4. The “LP” remains until you select a different operating modeor shut down the refrigerator.Do a test of the gas safety valve:1. Start up the refrigerator in the manual mode operation.2. Open the lower intake vent.3. Remove one wire from the solenoid of the gas safety valve atthe rear of the refrigerator.4. Within 30 seconds, the flame should extinguish. Thismeans that the gas safety valve is operating correctly.5. Put the wire back on the solenoid of the gas safety valve.6. Close the lower intake vent.Shut down:To shut down the refrigerator, push and hold the ON/OFF buttonfor two seconds.