Norcold N300 Service Manual

Also see for N300: Installation and owner's manual Parts list Installation and owner's manual Service manual

Contents

Norcold N300 Service Manual Manual pdf 12 page image

12 - Service Manual N300 ModelsThermocouple1. Close the valve at the main propane gas tank(s).2. Remove the thermocouple from the thermocouple inter-rupter.3. Remove the burner box cover.4. Remove the two screws that attach the thermocouple brack-et to the burner box.5. Remove the thermocouple from the thermocouple bracket.6. Remove the wires from the thermocouple interrupter.7. Using two wrenches, loosen the thermocouple interrupterfrom the safety valve.8. Turn the thermocouple interrupter about half way out of thesafety valve.9. Turn the thermocouple only about half way into the thermo-couple interrupter.10. Using two wrenches, fully tighten the thermocouple inter-rupter onto the safety valve.11. Fully tighten the thermocouple onto the thermocoupleinterrupter.12. Attach the wires to the thermocouple interrupter.13. Do steps 1-5 in reverse.14. Examine all the gas connections for leaks.Thermocouple interrupter1. Close the valve at the main propane gas tank(s).2. Remove the thermocouple from the thermocouple inter-rupter.3. Remove the wires from the thermocouple interrupter.4. Using two wrenches, remove the thermocouple interrupterfrom the safety valve.5. Turn the replacement thermocouple interrupter only abouthalf way into the safety valve.6. Turn the thermocouple only about half way into the replace-ment thermocouple interrupter.7. Using two wrenches, fully tighten the thermocouple inter-rupter onto the safety valve.8. Fully tighten the thermocouple onto the thermocouple inter-rupter.9. Attach the wires to the thermocouple interrupter.10. Open the valve at the main propane gas tank(s).11. Examine all the gas connections for leaks.5. Remove the insulation.6. Pull the AC heater up and out of the heater well.7. Push the replacement AC heater down into the heater well.- Make sure the bead of weld on the AC heater touches thetop of the heater well.8. Put the insulation around the flue tube.- Make sure the insulation is completely around the fluetube.9. Tape the insulation closed.10. Attach the two blue wires of the AC heater to the terminalblock.11. Put the AC power cord in the receptacle.DC heater (3-way models)1. Remove the DC input leads from the refrigerator.- Put tape on the positive lead to prevent an accidental elec-trical short and a blown fuse.2. To make sure the other energy sources do not activate, turnthe selector switch to the OFF ( ) position.3. Remove the two yellow wires that connect the DC heater tothe terminal block.4. Using a utility knife, vertically cut through the insulation thatsurrounds the flue tube.5. Remove the insulation.6. Pull the DC heater up and out of the heater well.7. Push the replacement DC heater down into the heater well.- Make sure the bead of weld on the DC heater touches thetop of the heater well.8. Put the insulation around the flue tube.- Make sure the insulation is completely around the fluetube.9. Tape the insulation closed.10. Attach the two yellow wires of the DC heater to the termi-nal block.11. Make sure that a 20 Amp fuse is in the fuse holder.12. Attach the DC input leads from the refrigerator.