Installation Manual 51. Make sure the clearance at the rear of the refrigerator iscorrect:- If there is more than 1 inch of clearance between the rear ofthe refrigerator and the enclosure, install two baffles [14] tothe rear of the enclosure (see Art01284 and Art01287).- Put one baffle at the top edge of the lower intake vent[1].- Put the other baffle at the lower edge of the condenser[3] of the refrigerator.- Make sure the baffles are less than 1/4 inch from thecoils [2] and condenser of the refrigerator.- Make sure the baffles are the full width of theinside of the enclosure.2. Put the refrigerator in position (see Art01288):WARNING: Make sure the combustion seal [15] is notbroken, is completely around the refrigerator mountingflanges [16], and is between the mounting flanges andthe wall of the enclosure. If the combustion seal is notcomplete, exhaust fumes can be present in the livingarea of the vehicle. The breathing of exhaust fumes cancause dizziness, nausea, or in extreme cases, death.- Remove the door from the refrigerator (See “Reverse thedoor swing” section).- Put screws through the holes of the refrigerator mountingflanges and into the enclosure wall.- Attach the door to the refrigerator.- Put a screw through the holes [17] in the braces at the lowerrear corners of the refrigerator and into the floor.Install the decorative door panel:NOTE: The decorative panels must be 3/16 inch or less inthickness.- For N400 models, make a decorative door panel [1] that is31 inches high x 21 5/16 inches wide (See Art00977).- For N500 and N510 models, make a decorative door panel[1] that is 37 inches high x 21 5/16 inches wide (SeeArt00977).- Push the decorative door panel into the slots of the doorend caps [2].- Push each panel retainer [3] into the slot on the edge of thedoor.Installation OptionsInstall the Refrigerator Reverse the door swing:This refrigerator has hinges that allow you to change thedirection that the door opens by moving the hinges to theopposite corner (See Art01313).1. Remove the door:- Turn out and save the upper hinge pin [1].- Open the door a small amount and pull the top of the dooraway from the upper hinge of the refrigerator.- Lift the door off of the lower hinge pin [2].- Turn out and save the lower hinge pin.2. Change the position of the hinges:- Remove the screws from the upper hinge [3].- Put this hinge on the other side as the lower hinge.- Attach the hinge with the screws.- Turn the lower hinge pin down into this hinge.- Remove the screws from the lower hinge [4].- Remove the screws from the travel latch [5].- Put this hinge on the other side as the upper hinge.- Attach the hinge with the screws.3. Change the position of the travel latch (See Art01313 andArt01571):- Put the travel latch on the other side of the refrigerator.- Attach the travel latch with the screws.- Remove the screw [6] from the travel latch plate [7] on thedoor.- Remove the screw [6] from the filler plate [8] on the door.- Put the travel latch plate on the other side of the door.- Attach the travel latch plate with the screw.- Put the filler plate on the other side of the door.- Attach the filler plate with the screw.