Norcold N610 Installation Manual

Also see for N610 -: Owner's instructions Parts list

Contents

Installation Manual 7- Push the bottom trim piece [15] onto the front of the refrig-erator.- Put two screws [16] through the trim piece, the mountingflange, and into the floor.- Put screws through mounting flange on the rear of therefrigerator and into the floor.Reverse the Door Swing-Nonmetal Doors(optional)This refrigerator has cabinet hinges that allow you to changethe direction the door opens by moving the hinges on a diago-nal to the opposite side.1. Remove the doors (See Art01726):- Remove the storage bins from the doors.NOTE: Do not mix the upper and lower hinge pins becausethey are different.- Remove and save the upper hinge pin [1] from each door.- Pull the door latch and remove each door from the refrigera-tor.- Remove and save the lower hinge pin [5] from each hinge.2. Change the position of the cabinet hinges and the strikeplate (See Art01728):- Remove and save the screws from the strike plate [2a].- Remove the two plastic hole caps that are near the strikeplate.- Remove the L-shaped plastic covers that are opposite thehinges.- Remove and save the screws from the upper cabinet hinge[3a] of each door.- Put each of these hinges on the other side of the refrigera-tor as the lower hinge [3b].- Attach each of these hinges with screws.- Remove and save the screws from the lower cabinet hinge[4a] of each door.- Put each of these hinges on the other side of the refrigera-tor as the upper hinge [4b].- Attach each of these hinges with screws.- Put the L-shaped plastic covers over the holes that wereused by the hinges.- Remove and save the screw [7] from the front box [6] (SeeArt01573).- Pull the front box away from the refrigerator and out fromunder the controls [8].- Reverse the front box and put it on the opposite side of thecontrols.- Attach the front box to the refrigerator with the screw.- Put the strike plate on the opposite side of the refrigerator[2b].- Put the two round plastic caps into the holes that are nearthe strike plate.3. Change the position of the door handles (See Art01727):- Remove the screws [12] and door handle [10] from eachdoor.- Reverse each door handle and put the lower door handleon the upper door and the upper door handle on the lowerdoor.- Attach each door handle with the screws.4. Reinstall the doors (See Art01726):- Turn the lower hinge pins into the lower cabinet hinges.NOTE: To prevent damage to the threads of the hinge pins,turn the hinge pins by hand until tight and thentighten with a screwdriver.CAUTION: Apply Loctite removable thread locker (blue)to the threads of the hinge screws before assembly toprevent loosening during use. Do not allow Loctite tocontact any of the plastic surfaces of the refrigeratorbecause it can damage those surfaces.- Put each door down onto the lower hinge pin.- Align the holes in the upper hinges and hold in this position.- Turn the upper hinge pin into the hinges of each door.- Tighten the hinge pins.- Put the storage bins in the doors.