|
Owner’s Manual 6Operating the Refrigerator Controls(N62X, N62XXX, N82X, and N82XXXmodels)Control panel:The refrigerator control panel (see Art01019) is between thefreezer compartment and the fresh food compartment. A 12 voltDC power supply is necessary for the control functions of therefrigerator to operate. The refrigerator receives DC power fromthe 12 volt system of the vehicle; either an auxiliary battery, aconverter, or the vehicle engine battery.The ON / OFF button [1] starts and shuts down the refrigerator:- To turn on the refrigerator, push and release the ON / OFFbutton.- To turn off the refrigerator, push the ON / OFF button for onesecond and then release.The TEMP SET button [2] controls the temperature adjustmentof the freezer and the fresh food compartment. The temperatureadjustment that you select does not change if the mode ofoperation of the refrigerator changes.Door alarm:(N64X, N64XXX, N64XIM, N64XIMXX, N84X, N84XXX,N84XIM, and N84XIMXX models)The refrigerator has an alarm to alert you if the fresh foodcompartment door is not closed. The refrigerator continues tooperate, but if the fresh food compartment door is open and theinterior light remains on for two minutes:- An audible alarm starts.- “dr” appears in the center display.- The interior light automatically turns off.Close the door to silence the alarm.Moisture reduction heater:The refrigerator has a heater that prevents moisture fromforming on the center divider between the doors of the freezerand the fresh food compartment. The heater operates onlywhen the refrigerator is ON and the DC power is sufficient.Temperature control system:Although the refrigerator is not frost -free, it is made to limit froston the cooling fins. At regular intervals, the temperature controlsystem automatically melts most of the frost from the coolingfins. The water from the cooling fins drains into a collection cupthat is attached to the back of the refrigerator. The heat of thecooling system evaporates the water from the collection cup.Backup operating system:This refrigerator has a backup operating system. The backupoperating system allows the refigerator to continue to cool if thetemperature sensor of the refrigerator should fail.If this failure occurs:- The refrigerator automatically changes to the backupoperating system.- When you push the TEMP SET button, the temperaturesetting flashes in the center display for ten seconds.- After the temperature setting flashes, the mode ofoperation appears in the center dispaly.- The backup operating system can overfreeze or thaw thecontents of the freezer and the fresh food compartment.- Make sure the temperatures of the freezer and the freshfood compartment are satisfactory.NOTE: If you open the door(s) too often, the tempera-tures inside the freezer and fresh food compart-ment do not become stable. Allow the refrigera-tor to operate for about one hour after eachadjustment change before you examine thecontents. The number “9” is the coldesttemperature setting.- If the temperature is too warm, push and hold theTEMP SET button to raise the temperature settingby one number.- If the temperature is too cold, push and hold theTEMP SET button to lower the temperature settingby one number.- Have the refrigerator serviced by your dealer or a Norcoldauthorized Service Center as soon as possible.
PreviousNext |