Norcold N62X Installation Manual

Also see for N62X: Owner's instructions Service manual Service manual Owner's manual Owner's manual

Contents

Norcold N62X Installation Manual Manual pdf 9 page image

Installation Manual 9- Reverse each door handle and put the lower door handle onthe upper door and the upper door handle on the lower door.- Attach each door handle with a cap screw [72] and screws[41].- Put the plastic cap into the hole that is opposite the upperhinge of the upper door.4. Reinstall the doors (See Art00986):- Make sure each hinge bushing [74] is in the correct position.- Put each hinge bushing into the bottom side of eachdoor hinge.- Put each door in the position on the refrigerator.NOTE: To prevent damage to the threads of the hinge pins,turn the hinge pins by hand until tight and then tightenwith a screwdriver.CAUTION: Apply Loctite removable thread locker (blue)to the threads of the hinge screws before assembly to pre-vent loosening during use. Do not allow Loctite to contactany of the plastic surfaces of the refrigerator because itcan damage those surfaces.- Align the hinges and put the hinge pins into each door.- Tighten the hinge pins.- Put the storage bins in the doors.The ice maker is assembled to the refrigerators at the factory asoptional equipment. If the refrigerator does not have a factoryinstalled ice maker, one can not be added to the refrigerator at alater time.The refrigerator installer must connect a cold water supply lineto the solenoid valve at the rear of the refrigerator. The followingare necessary to connect the icemaker:- 1/4 in. OD copper tubing for the water supply line.OR- 1/4 in. OD plastic tubing for the water supply line.Connect the Ice Maker(N64XIM, N64XIMXX, N84XIM, andN84XIMXX models)- 1/4 in. shut off valve in the water supply line. This should beeasily accessible through the lower intake vent.Connect the water supply line:Install a 1/4 in. OD water supply line [43] from the water shut offvalve of the vehicle to the solenoid water valve [44] at the rear ofthe refrigerator (See Art01014):NOTE: A brass compression nut [45], a brass sleeve, a plasticsleeve [46] , and a brass insert [47] are supplied andattached to the rear of the refrigerator (See Art01755).- Put the compression nut and then the sleeve onto the watersupply line [43].- For copper tubing, use the brass sleeve.- For plastic tubing, use the plastic sleeve [46].- For plastic tubing with .040 in. wall thickness, also usethe brass insert [47].- Flush the water supply line until the water is clear.- Put the tubing into the water valve until it is against the stop.- Tighten the compression nut by hand (hard finger tight).- Using two wrenches, tighten the compression nut 1 ½ to 2turns.- Open the water shut off valve of the vehicle.- Examine the connections for leaks.Connect the Electrical ComponentsAC Operation 120 volts AC voltage(132 volts max. - 108 volts min.)12 volts DC control voltage(15.4 volts max. - 10.5 volts min.)DC Operation 12 volts DC control voltage(15.4 volts max. - 10.5 volts min.)This refrigerator operates on these electrical sources. Operationout of these limits may damage the refrigerator’s electrical circuitparts and will void the warranty.!